Contact Us|Message|Site Map|中文|日本語

Welcome to HEFEI TRUE P ELECTRONIC TECHNOLOGY CO.,LTD.
Hefei Zhenping There are electronic technology Co.,Ltd.With the design, manufacture, sales and after-sales service capabilities of the integrated enterprise
图片1.pngHotline:400-608-2908
新闻活动Banner

Contact Us

HEFEI TRUE P ELECTRONIC TECHNOLOGY CO.,LTD.

Hotline: 400-608-2908

Fax: 0551-63484895

Add: Hefei National Economic and Technological Development Zone Su Song Road and Tsinghua Road, Enlightenment Science and Technology City, a space room A Building Room 1004-1007

Location: 首页  »   News  »   Industry News  »   "Five do not" make you better use of high and low temperature test chamber

Industry News

"Five do not" make you better use of high and low temperature test chamber

Source:Zhenping Time:2017-08-04 Views:

High and low temperature test chamber in operation, there are some prohibited things, Xiaobian finishing for the five do not, and to share with you, hoping to give you some effective help.

High and low temperature test chamber

1. The temperature difference is not too much: the use of the environment temperature is too large, will lead to high and low temperature test chamber, in use to produce a lot of water vapor, over time will accelerate the corrosion of components, it is easy to cause damage to equipment;

2. Do not close to the heat source: the device placed on both sides of the location should be reserved 60-70 cm of the use of maintenance space, which can also help the device cooling, but also pay attention not to put together some heating appliances, so as not to increase the high and low temperature The power consumption of the test chamber.

3. Do not frequent switch: winter general office temperature of 0 ~ 20 ℃ or so, and the device's operating temperature is relatively high, if frequent switching, its internal components may be in the high and low temperature changes in the destruction ;

4. In the use of equipment, if necessary, open the door, should shorten the time, in case of power failure, do not rush to open the test chamber door, because in a certain period of time, the box still have a certain temperature, if the factory time no power, Need to be re-tested.

5. Do not disable the high and low temperature test chamber: a lot of customers in order to save power, if the high and low temperature test chamber temporarily less than then it will be in a "hibernation" state, in fact, this is unscientific, is likely to affect the high Low temperature test chamber life, because the high and low temperature test chamber evaporator are mostly aluminum products, deactivated after the aluminum wall of organic matter will be mildew, corrosion of aluminum, damage to the refrigeration system, and the liner of plastic at room temperature is easier than the low temperature Aging, therefore, it is best not to let high and low temperature test chamber "downtime";

If you have to say that you must disable the high and low temperature test chamber, it must be defrosted, clean, put it in a ventilated place, to avoid direct sunlight, it is best to give high and low temperature test chamber A power, so that the normal operation of the compressor half an hour to an hour before closing;

The above is on the high and low temperature test chamber of the "five do not", I hope we can strictly according to the requirements of operation, the only way to make your equipment longer life.

Related News